- 500W Peak Power
- 300W RMS x 1 at 4ohms
- 500W RMS x 1 at 2ohms
- RMS Watts per channel @ 4 ohms, 1% THD+N 83 dBA
- Signal to Noise Ratio (Reference: 1 Watt into 4 ohms)
All in all though I am pleased with this amp. Powerful enough. Small and compact. Barely gets hot. Even after hours of hard running. Uses barely any juice. Played for about 6 hours without the car running. Not so lucky with past amps. Lets just say had to replace a couple car batteries. Would have given it a 4 or 5 star review if it were just a little more consistent with its power distribution. Anyways, still a good amp for a simple setup.I put this in my truck 2 months ago and since then it has been working great. I have it all wired with 8 gauge stinger wiring to the 4 ohm shallow 10 inch Kenwood excelon sub. This combinations bumbs! The amp barely gets warm after a hour of use and i have had no problems with it at all. I like how small and easy to install it is because it's class D so you can almost put it anywhere. Puts out plenty of power especially in my single cab. The on-board fuses are nice to have too! Definitely a good buy.I purchased this to power a single twelve in a ported box and it gets the job done and done well. merchandise came exactly as advertised and shipping was really fast especially since it was so close to Christmas.Cannot go wrong with Kenwood Excelon Amps. This is an awesome product! Currently have a single 10" Kenwood Excelon Sub and the match is perfect!Great amplifier powering one 12, this amp delivers the goods. If your looking to make an investment in car audio and do not have much money then this will suit your needs for a beginner.
No comments:
Post a Comment